Effective Characteristic Impedance


Reading time ( words)

In a typical interconnect, there lie multiple places where capacitance plays a factor in the signal integrity. This includes the driver and receiver output/input capacitance, as well as the packages, vias, and the transmission lines. Failing to optimize these parameters can often lead to unwanted reflections, excessive radiated and or conducted emissions, and sometimes failure of components and systems.

Reflections can occur anytime there is an impedance mismatch on the line. Sources of mismatches are plentiful and include trace width changes, vias, stubs, reference plane changes, and even the so-called fiber weave effect. In this case, a trace can encounter a different dielectric constant depending on whether it is routed over glass or the epoxy resin in the dielectric material. 

In this investigation, it is the capacitive contribution of the different components that are of interest, and how they affect the characteristic impedance the driver sees. 

To read the rest of this article, click here.

Share




Suggested Items

Designing PCBs With Additive Traces

04/28/2022 | Tomas Chester, Chester Electronic Design
Advances in technology have been clear to see within the component packaging industry, as the ball grid array (BGA) package sizes reduce from 1.0 mm pitch to 0.8 mm, 0.4 mm, and even beyond. However, while these improvements have occurred with component packages, it has become increasingly more difficult to break out and route the dense circuitry associated with these parts. Currently, the high-density interconnect (HDI) method typically used for the breakout of such parts has been to create the smallest possible subtractive-etched traces with microvias to allow for connections and escapes on the innerlayers of your PCB.

Does Copper Pour on a Signal Layer Decrease Signal-To-Signal Isolation?

04/07/2022 | Steve Hageman, Analog Home
Does putting a ground pour on PCB signal layers make the isolation better or worse? It can go either way, but with the proper knowledge and application, this technique will improve your designs. In this article, I’ll discuss how to simulate trace-to-trace isolation with true electromagnetic simulation software. We’ll also cover a variety of rules of thumb that can help you stay away from trouble.

High-Voltage Circuit Design Guidelines and Materials

02/08/2022 | Celso Faia and Davi Correia, Cadence Design Systems
The Hubble telescope, the Cassini-Huygens mission, and other exploratory spacecraft utilize high-voltage DC power supplies for everything from vidicon camera tubes and mass spectrometers to radar and laser technologies. NASA has experienced performance problems with the 1.5 kV supplies because—as a 2006 report stated—“designers did not take the high-voltage problems seriously in the initial design.” The report cited very narrow parts parameters, electrical insulation problems in dielectrics, ceramics, bad geometries, small spacing, the use of the wrong insulating materials, and thermal expansion as causes for the power supply failures.



Copyright © 2022 I-Connect007. All rights reserved.